Did you ever need to jump-start your car only to discover that the battery was mired in crud? That nasty gunk is in fact battery corrosion thats formed by acid condensation. Fortunately, to clear out the acid build-up, you just need to utilize a basic chemical solution. Something as very basic as baking soda could quickly clean the battery acid. You’ll want to take some safety measures, but safe cleaning of your battery is just following a few instructions.

Safety First

First off, you’ll need the tools which you can get easily at home. You mainly need safety glasses for the eyes, baking soda, adaptable pliers and screwdrivers with insulated handles and a stiff-bristled brush. Other things you need consists of a metal or plastic scraper, box or open-end wrenches, cleaning brushes for the battery terminal, and either a turkey baster or small funnel. You must also have a number of sponges, spray-type household cleaner, rubber gloves in addition to a bucket of clean water. It may look like a lot of stuff to clean the equipment, but it will keep it safe and non-hazardous.

Since the corroding deposits contain sulfuric acid, I suggest you use rubber gloves and safety glasses. You should make sure that the deposits do not get on the car since it will damage the paint. Depending on the amount of dirt and corrosion on the battery, the cleaning can vary, and some of the steps might not be necessary. If you’d like the battery to be very clean, you will need to remove the battery from the vehicle. The initial step is to try using the scraper to eliminate as much dirt as possible and use the bristle brush to get at more.

Cleaning Solution

Next step is to put together one tablespoon of baking soda with a pint of water and add the solution to the battery and the cable connection using the funnel or turkey baster. Then you’re able to use the bristle brush to loosen and remove the build up from the battery and you want to remove the cables so that cleaning will be easier. If disconnecting the battery, be sure to use the pliers or wrenches to loosen the connection and take them off with negative first then positive. Brush aside all of the decay from the terminals and all of the parts, and then flush each one with the baking soda solution.

You can use the bottle of spray cleaner and sponge to remove any excess dirt and grease. Following that, dry all the components with a clean cloth and reassemble everything plus be sure that the cable is connected positive first. Double check things are secure and you finally have a clean, safe battery.